ATEX and IECEx certified explosion-proof displays and monitors purpose-built for Zone 1, Zone 2, Zone 21, and Zone 22 hazardous areas where flammable gases, vapours, or combustible dusts create a risk of ignition. Engineered for the oil & gas, petrochemical, offshore platform, chemical processing, and underground mining industries, these rugged monitors feature Ex d flameproof or Ex p pressurised-purge enclosures in marine-grade 316L stainless steel or GRP composite, with IP66/IP67 hermetic sealing. Sunlight-readable IPS panels up to 1000 nits, wide-temperature operation from −40 °C to +60 °C, and resistive or gloved-hand PCAP touch give operators clear, reliable control in the harshest classified locations worldwide.
Certified to ATEX Directive 2014/34/EU and IECEx for installation in Zone 1 (gas) and Zone 21 (dust) hazardous areas — the most demanding classified locations.
Cast 316L stainless steel Ex d flameproof housing that contains any internal ignition and quenches flame paths before they can reach the surrounding explosive atmosphere.
Ex p Type X/Y/Z purged enclosures continuously flushed with instrument air or inert gas to prevent hazardous-area atmosphere entering the monitor housing.
Marine-grade 316L stainless steel or fibreglass reinforced plastic (GRP) enclosure resisting H₂S, saltwater corrosion, and chemical splash in offshore and petrochemical sites.
Fully hermetically sealed to IP66 and IP67, preventing ingress of high-pressure water jets, washdown fluids, and fine hydrocarbon dust in process plant environments.
Up to 1000 nit high-brightness IPS display with anti-reflective coating for clear outdoor and open-top plant visibility without exposing internal electronics to the hazardous zone.
Standard industrial monitors are strictly prohibited in ATEX Zone 1 and Zone 2 hazardous locations because internal sparking, hot surfaces, or component failure could ignite surrounding flammable gas or dust clouds. Our ATEX certified displays are engineered around two core protection concepts: Ex d flameproof enclosures that contain any internal ignition, and Ex p pressurised purge systems that displace hazardous atmosphere from inside the housing. The 316L stainless steel body resists H₂S corrosion, offshore saltwater environments, and aggressive chemical cleaning. Combined with IP66/IP67 hermetic sealing, certified Ex e terminal entries, and intrinsically safe cable glands, the complete installation meets ATEX Directive requirements without exception — giving operators the confidence to interact with process HMIs safely inside the most hazardous plant areas.
Video signals enter via intrinsically safe (IS) Zener barriers or galvanic isolators keeping energy within safe limits inside the zone.
Power enters via certified Ex d or Ex e cable gland entries with integral transient surge protection to IEC 61643.
M20, M25, or M32 certified flameproof or increased-safety cable glands for armoured or unarmoured signal and power cables.
Resistive touch or intrinsically safe PCAP touch interface operating safely within Zone 1 energy limits without hot-work permits.
Configure gas group, temperature class, enclosure material, purge system, and cable entry types for your specific classified zone and process environment.